Char-Broil 463262811 - Manual (Page 21)

13
A
21
Inside of cart, insert heat shield rear tabs(without holes) into slots between upper and lower back panels. Then insert
left and right grease tray rails into slots beneath grease tray opening in upper back panel. Then insert end of tank wire
into right arcuate slot on lower back panel, shown A.
Attach left and right rails to the bottom of front brace with two #8X3/8” self tapping screws. Attach heat shield front tabs and
tank wire to the bottom of front brace with two #8X3/8” self tapping screws, sown B.
Some components not shown for
illustration purposes.
Front brace
Front brace
Heat shield
Tank wire
Tank wire
Left grease tray rail
Right grease tray rail
#8x3/8” tapping
Screw
Rails
#8x3/8” tapping
Screw
B