Chauvet Q-WASH 360Z-LED - Manual (Page 18)

Operation
-14- Q-Wash 360Z-LED User Manual Rev. 01g
Menu Map
1
st
Level 2
nd
Level 3
rd
Level Description
INTRO
ADDRESS 001~512 Selects a starting DMX address
RESET NO/YES Resets the fixture’s custom settings
FAN
HIGH
Select the fan’s operation mode.
NOTE: The fan will go to High mode if the fixture’s internal
temperature becomes too high, despite any manual or
DMX setting
NORMAL
LOW
AUTO
RUN
DMX512 Selects DMX running mode
AUTO 1 Selects the first automatic program
AUTO 2 Selects the second automatic program
CUSTOM Selects the user customizable program
SLAVE Selects the Slave running mode
TEST Starts the fixture’s test sequence
CHANNELS
BASIC Selects the 11-channel DMX mode
ADVANCED Selects the 15-channel DMX mode
DISPLAY
60 CLOSE Turns off the display after 60 seconds
BRIGHT Keeps the display on
KEYLOCK NO/YES Activates/deactivates the control panel password
DIMMER
DIMMER4~1 Slow (DIMMER4) to fast (DIMMER1) dimmer curves
DIMMER0 Linear dimmer
INFO EDITION Shows the version of the installed S/W
INVERT
PAN
NORMAL/
REVERSE
Defines the direction of the pan fader
TILT Defines the direction of the tilt fader
DIMMER Defines the direction of the dimmer fader
USE NO/YES Activates the changes
RANGE
P/START
000~255
Sets the pan start point (restricted range)
P/FINISH Sets the pan end point (restricted range)
T/START Sets the tilt start point (restricted range)
T/FINISH Sets the tilt end point (restricted range)
USE Activates the changes
SPECIAL
BLACKD NO/YES Activates the move-in black delay (3 s)
RESET
DMX The DMX controller can reset the fixture
SYSTEM The control panel can reset the fixture
POWER
NORMAL/
HIGH
LEDs illuminate at normal or high intensity
NOTE: The fixture will return to Normal if the LEDs’
temperature becomes too high
COLOR
UC RGBW = 255: The output matches that of older fixtures
RGBTOW RGBW = 255: The RGBW output is set by RGB-W
OFF RGBW = 255: The RGBW output is maximum
FAN
DMX The DMX controller can set the fan speed
SYSTEM The control panel can reset the fan speed
EDIT
STEP
000~255
Selects the program step
PAN Selects the pan position
TILT Selects the tilt position
SPEED Selects the pan/tilt speed
RED
Combines red, green, blue, and white to obtain a custom
color GREEN
BLUE
WHITE
Continues on the next page