Chauvet Q-WASH 360Z-LED - Manual (Page 12)

Setup
-8- Q-Wash 360Z-LED User Manual Rev. 01g
Mounting Before mounting this product, read and follow the safety recommendations indicated in the
Safety Notes section (page 2 of this manual).
Orientation Always mount this product in any safe position while making sure that there is adequate
room around it for ventilation, head motion, configuration, and maintenance.
Rigging CHAUVET® recommends following the general guidelines below when mounting this
product.
· When selecting an installation location, consider ease of access to the fixture for
operation, programming adjustments, and routine maintenance.
· Make sure to mount this product away from any flammable material, as indicated in the
Safety Notes section, or obstructions that may block the moving head.
· Never mount the product in places where rain, high humidity, extreme temperature
changes, or restricted ventilation may affect it.
· If hanging this product, make sure that the location where you are mounting it can
support its weight. Please see the Technical Specifications section of this manual for
the weight requirement of this fixture.
Procedure
The Q-Wash 360Z-LED comes with two omega brackets to which you can attach “C” or “O”
clamps. You must supply your own “C” or “O” clamps and make sure that they are capable
of supporting the weight of this fixture. You will have to use two mounting points per fixture.
The omega brackets also serve to anchor this product to a panel. For floor standing
operation, this product has built-in rubber feet.
Product Mounting
Diagram
Safety Cable (included)
C clamp (not included)
Omega bracket (included)
Overhead Mounting Floor Standing