Cooper Bussmann VERSION 1.6 BU-945U-E 802.11 DSSS - Manual (Page 43)

www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann Wireless Ethernet & Device Server BU-945U-E 802.11 DSSS User Manual
43 3A1582Rev1.6
Select “Blacklist” or “Whitelist” Blacklist will prevent all listed devices from accessing the module and using the radio link.
Whitelist will allow devices with the IP addresses listed to communicate with the module and utilize the
radio link. All other devices are blocked.
Add Entry Add a row to the table of IP Address filter rules
Delete Entry Delete the currently selected IP address filter rule.
Enable Check this box to enable the rule
IP Address Min, IP Address Max These set the range of IP addresses. All addresses within the specified range are affected by the rule.
Port Min, When the protocol is set to TCP or to UDP, this is the range of
Port Max port addresses to which the rule applies. When protocol is set to All or to ICMP, these settings
have no effect.
Protocol This chooses the protocol to which the rule applies. The rule can apply to Any protocol
(All), or to only one of TCP, UDP, or ICMP (Ping).
Save Changes Save changes to non-volatile memory (Reset is required to activate)
Save Changes and Reset Save to non-volatile memory and restart to activate changes
ARP Filter Configuration:
ARP (Address Resolution Protocol) is a broadcast message and is primarily used for finding a MAC address when only its IP or some other
Network Layer address is known.
On large networks, you generally tend to get a high proportion of broadcast messages. Using ARP filters is useful for reducing broadcast traffic on
the wireless network by only allowing ARP requests for known units to pass, or blocking ARP requests for high use addresses.
Select “Blacklist” or “Whitelist” A Blacklist will block ARP requests that match the entry.A Whitelist will allow only ARP Requests that
match the entry. All other devices are blocked.
Add Entry Add a row to the table of ARP Address filter rules
Delete Entry Delete the currently selected ARP address filter rule.
Enable Check this box to enable the rule
IP Address This sets the IP address that you wish to filter.
IP Netmask Sets the IP Netmask
Save Changes Save changes to non-volatile memory (Reset is required to activate)
Save Changes and Reset Save to non-volatile memory and restart to activate changes.