Clarion NX509 - Manual (Page 57)

55
NX509
English
Owner
’s ma
nua
l
USB Devices
If an error display other than the ones described above appears, press the Reset button. If the problem
persists, turn off the power and consult your store of purchase.
• The frequencies of radio stations, setting data, etc. stored in memory are not cleared even when the
Reset button is pressed.
Display Cause Measure
Error 2 The connected USB device
is not supported. If the USB device is frozen, disconnect it, reset it,
and reconnect it again.
Connect a proper USB device.
Error 3
(USB memory) An error occurred when
controlling the USB device. Disconnect the USB device, and reconnect it
again.
Error 3 (iPod) The selected category has
no track data. Touch the [
{ (Track)] key. If the error is not
cleared, disconnect the iPod, and reconnect it
again.
The iPod is frozen. Disconnect the iPod, reset it, and reconnect it
again.
Error 5 (iPod) The connected iPod is not
recognized. Disconnect the iPod, and reconnect it again. If the
iPod is still not recognized, try replacing with a
different iPod.
If the iPod is frozen, disconnect it, reset it, and
reconnect it again.
Bus Error Over-current or data error
is detected. Turn off the ignition switch, disconnect the device,
restart the engine and reconnect it again. If the
device is still not recognized, try replacing with a
different device.
Device Error The device is connected
via the USB Hub. Disconnect the device, and reconnect directly to
the USB connector of this unit without using the
USB Hub.
DRM WMA files protected by
DRM are played. Perform the operation such as skipping a file.
(Repeat and random playback mode may be
canceled.)
Not Support Files not supported by this
unit are played.