beautypg.com

To add, reprogram or change a keyless entry pin – Craftsman 139.53915D User Manual

Page 36

background image

1. Enter a four digit personal identification

number (PIN) of your choice on the
keypad. Then press and hold ENTER.

2. While holding the ENTER button, press

and hold the LIGHT button on the Motion
Detecting Control Console.

3. Continue holding the ENTER and LIGHT

buttons while you press the push bar on
the Motion Detecting Control Console
(all three buttons are held).

4. Release buttons when the motor unit

lights blink. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.

1. Press and release the “learn” button on

motor unit. The learn indicator light will
glow steadily for 30 seconds.

2. Within 30 seconds, enter a four digit

personal identification number (PIN) of
your choice on the keypad. Then press
and hold the ENTER button.

3. Release the button when the motor unit

lights blink. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.

To Add, Reprogram or Change a Keyless Entry PIN

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.

USING THE “LEARN” BUTTON

USING THE MOTION DETECTING CONTROL CONSOLE

NOTE: This method requires two people if the Keyless Entry is
already mounted outside the garage.

To change an existing, known PIN

If the existing PIN is known, it may be changed by one person
without using a ladder.

1. Press the four buttons for the present PIN, then press and hold

the # button.

The opener light will blink twice. Release the # button.

2. Press the new 4-digit PIN you have chosen, then press ENTER.

The motor unit lights will blink once when the PIN has been
learned.

Test by pressing the new PIN, then press ENTER. The door
should move.

To set a temporary PIN

You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours or
number of accesses, this temporary PIN expires and will no
longer open the door. It can be used to close the door even after
it has expired. To set a temporary PIN:

1. Press the four buttons for your personal entry PIN

(not the last temporary PIN), then press and hold the ✽ button.

The opener light will blink three times. Release the button.

2. Press the temporary 4-digit PIN you have chosen, then press

ENTER.

The opener light will blink four times.

3. To set the number of hours this temporary PIN will work, press

the number of hours (up to 255), then press ✽.

OR

3. To set the number of times this temporary PIN will work, press

the number of times (up to 255), then press #.

The opener light will blink once when the temporary PIN has been
learned.

Test by pressing the four buttons for the temporary PIN, then
press ENTER. The door should move. If the temporary PIN was
set to a certain number of openings, remember that the test has
used up one opening. To clear the temporary password, repeat
steps 1-3, setting the number of hours or times to 0 in step 3.

K

I

T

O K

L GHT

O K

L G T

One Button Close: Opener can be closed by pressing only the ENTER button if the one button close feature has been activated. This
feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1 and 9 for 10 seconds. The
keypad will blink twice when the one button close is active. The keypad will blink four times when one button close is deactivated.

36