Compaq TRU64 AA-RNG2A-TE - Manual (Page 49)

lan_media_mode usually reflects how the media is to be selected. (In
contrast, the value that is stored in the lan_media member reflects the
current setting of the device.) Typically, you set this member in the
driver’s probe interface to the media mode constant that identifies the
mode for the media.
The lan_common.h file defines two enumerated data types called
media_types
and media_modes. You can set the lan_media_mode
member to one of the following values, which are defined by the
media_types
and media_modes enumerated data types:
LAN_MEDIA_UTP The mode for the media is unshielded
twisted-pair cable.
LAN_MEDIA_BNC The mode for the media is thin wire.
LAN_MEDIA_STP The mode for the media is shielded
twisted pair cable.
LAN_MEDIA_FIBER The mode for the media is any
fiber-based media.
LAN_MEDIA_AUI The mode for the media is the attachment
unit interface (AUI).
LAN_MEDIA_4PAIR The mode for the media is four-pair cable.
LAN_MODE_AUTOSENSE The hardware determines the media.
3 Defines an alternate name for referencing the lan_media_state
member of the lan_media data structure. The lan_media_state
member will be set only if lan_media_mode has the value
LAN_MODE_AUTOSENSE
. This member is typically set in the driver’s
probe( ) routine.
The lan_media_state member can be set to one of the following
constants, which are defined in the lan_common.h file:
LAN_MEDIA_STATE_SENSING The media is currently in the autosensing state.
LAN_MEDIA_STATE_DETERMINED
The media state has been determined.
4 Defines an alternate name for referencing the lan_media member
of the lan_media data structure. The lan_media member specifies
the currently set media.
The value that is stored in the lan_media member is valid in the
autosense mode only if the lan_media_state member is set to the
constant LAN_MEDIA_STATE_DETERMINED. The value that is stored in
lan_media
reflects the current setting of the device. (In contrast, the
value that is stored in the lan_media_mode member usually reflects
how the media is to be selected.) Typically, you set the lan_media
Defining the softc Data Structure 3–5