Compaq TRU64 AA-RNG2A-TE - Manual (Page 13)

New and Changed Features
This revision of the manual documents the following new features:
• Enabling support for enhanced hardware management
Enhanced hardware management (EHM) allows you to modify hardware
attributes, such as the type of LAN device, on either a local or a remote
system. See Section 3.2 for more information about how a network device
driver uses routines to define and export hardware attributes.
• The unattach( ) routine
The unattach( ) routine stops the network device and frees resources
prior to unloading the device driver or powering off the bus to which the
device is attached. See Chapter 7 for more information.
Organization
This manual is organized as follows:
Chapter 1 Describes the sections that make up a
network driver and compares them to
the sections that are associated with
block and character drivers.
Chapter 2 Describes the device register offset
definitions for the if_el device driver’s
associated LAN device, the 3Com 3C5x9
series Ethernet adapter.
Chapter 3 Describes how to define a softc data
structure, using the if_el device driver’s
el_softc
structure as an example.
Chapter 4 Describes how to implement a
configure
interface, using the if_el
device driver’s el_configure( )
routine as an example.
Chapter 5 Describes how to implement a probe
interface and associated routines, using
the if_el device driver’s el_probe( )
routine as an example.
Chapter 6 Describes how to implement an attach
interface, using the if_el device driver’s
el_attach( )
routine as an example.
Chapter 7 Describes how to implement an
unattach( )
routine to stop the device.
About This Manual xiii