Compaq TRU64 AA-RNG2A-TE - Manual (Page 125)

12
Implementing the ioctl Section
The ioctl section of a network device driver contains the code that implements
a network device driver’s ioctl interface. The ioctl interface performs
miscellaneous tasks that have nothing to do with data packet transmission
and reception. Typically, it turns specific features of the hardware on or off.
The el_ioctl( ) routine performs the following tasks:
• Determines whether the user has removed the PCMCIA card from the
slot (Section 12.2)
• Sets the IPL and obtains the simple lock (Section 12.3)
• Recognizes the ioctl command and performs the appropriate
operations. Table 12–1 lists the ioctl commands that network device
drivers must recognize.
• Releases the simple lock and resets the IPL (Section 12.17)
Table 12–1: Network ioctl Commands
ioctl Command Required Description For More Information
SIOCENABLBACK No Enables loopback
mode. Section 12.4
SIOCDISABLBACK No Disables loopback
mode. Section 12.5
SIOCRPHYSADDR Yes Returns the current
and default MAC
addresses. Section 12.6
SIOCSPHYSADDR Yes Sets the local MAC
address. Section 12.7
SIOCADDMULTI Yes Adds the device to a
multicast group. Section 12.8
SIOCDELMULTI Yes Removes the device
from a multicast
group. Section 12.9
SIOCRDCTRS Yes Reads counters. Section 12.10
SIOCRDZCTRS Yes Reads and zeros
counters. Section 12.10
SIOCSIFADDR Yes Brings up the device. Section 12.11
Implementing the ioctl Section 12–1