Christie Digital Systems 38-VIV210-01 - Manual (Page 12)

12
CONNECTING PROJECTOR
CONTROL PORT
INPUT 1
R/C JACK
USB
RESET (MONO)
(MONO)
AUDIO
INPUT 2
INPUT 3
SERIAL PORT IN SERIAL PORT OUT
AUDIO OUT
R L
L
R L ANALOG RGB
This port is used to service
this projector. Connect an audio output
from computer to these
jacks. (Refer to P13.)
CONTROL PORT CONNECTOR AUDIO INPUT JACKS
INPUT/OUTPUT TERMINALS AND JACKS
Connect computer output
(Analog HDB 15-pin type) to
this terminal.
(Refer to P13.)
HDB 15-PIN INPUT TERMINAL
Connect an external audio
amplifier to these jacks.
(Refer to P13.)
AUDIO OUTPUT JACKS
This projector uses a micro processor
to control a unit. Occasionally, this
micro processor may malfunction and
need to be reset. This can be done
by pressing RESET button with a
pen, which will shut down and restart
unit. Do not use RESET function
excessively.
RESET BUTTON
USB PORT (Series B)
SERIAL PORT
OUT TERMINAL
SERIAL PORT
IN TERMINAL
This port is used to service
this portt.
If you control a projector by computer,
you must connect a cable (not
provided) from your computer to this
terminal.
This terminal outputs signal from
SERIAL PORT IN. More than two
projectors can be controlled with one
computer by connecting SERIAL
PORT IN. of another projector to this
terminal.