Casio EX-H30 - Manual (Page 172)

172
Appendix
Other
The wrong date
and time are
displayed, or the
wrong date and
time are being
stored along with
image data. The date and time setting is off. Set the correct date and time
(page 145).
The messages on
the display are in
the wrong
language. The wrong display language is selected. Change the display
language setting (page 146).
Images cannot be
transferred over a
USB connection. 1)The USB cable may not be connected securely. Check all
connections.
2)The wrong USB communication protocol is selected. Select
the correct USB communication protocol in accordance with
the type of device you are connecting (pages 122, 132).
3)If the camera is not turned on, turn it on.
4)Your computer may not be able to recognize the camera if
you connect via a USB hub. Always connect directly to the
computer’s USB port.
Language selection
screen appears
when the camera is
turned on. 1)You did not configure initial settings after purchasing the
camera or the camera may have been left with a dead
battery. Check the camera setup (pages 16, 18).
2)There may be a problem with the camera’s memory data. If
this is the case, perform the reset operation to initialize the
camera’s setup (page 150). After that, configure each setting.
If the language selection screen does not re-appear when you
turn the camera on, it means that the camera’s memory
management data has been restored.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
Problem Possible Cause and Recommended Action