Nikon L105 User Manual
Page 27
15
Inserting the Batteries
First Ste
p
s
B
Removing the Batteries
Before opening the battery-chamber/memory card slot cover, turn the camera off and confirm that
the power-on lamp and the monitor are off.
B
Additional Precautions Regarding Batteries
• Read and follow the warnings and cautions (A iii, 117).
• Be sure to read and follow the warnings for the battery on page iii and the section, “The Battery”
(
A 117), before using the battery.
• Do not combine old and new batteries or batteries of different makes or types.
• Batteries with the following defects cannot be used:
B
Notes on the EN-MH2 rechargeable Ni-MH batteries
When using EN-MH2 batteries with the COOLPIX L105, charge the batteries four at a time using
Battery Charger MH-73 (
B
Battery Type
To improve battery performance, set the Battery type setting (
A 112) in the setup menu (A 92) to
match the type of batteries inserted into the camera.
The default setting is the type of battery supplied with purchase. When any other type of battery is
used, turn the camera on and change the setting.
C
Alkaline Batteries
Performance of alkaline batteries may vary greatly depending on the manufacturer. Choose a reliable brand.
C
Alternative Power Sources
To power the camera continuously for extended periods, use an AC Adapter EH-67 (available
separately) (
A 120). Do not, under any circumstances, use another make or model of AC adapter.
Failure to observe this precaution could result in overheating or in damage to the camera.
C
Auto Off (Standby Mode)
If no operations are performed for a specified amount of time, the monitor turns off, the power-on
lamp flashes, and the camera enters standby mode. After an additional three minutes, the auto power
off feature turns the camera off.
• During shooting or playback, the camera enters standby mode if no operations are performed for
30 seconds (default setting).
• During standby mode, the monitor is off and the power-on lamp flashes; you can turn the monitor
on by pressing any of the following buttons: power switch, shutter-release button, A button,
c
button, or the
b (movie-record) button
• The amount of time that passes before the camera enters standby mode is determined by the
Auto off setting (
A 106) in the setup menu (A 92).
C
Lens Error
If Lens Error is displayed, make sure that the lens cap has been removed, then turn the camera on again.
Batteries with peeling
Batteries with insulation that
does not cover the area
around the negative terminal.
Batteries with a flat
negative terminal