Cisco 1711 - Manual (Page 6)

6
6
Connecting a PC to the Router’s Console Port
This step is optional, and required only if you want to use the Cisco IOS CLI to configure or troubleshoot the router, instead of
SDM. To use Cisco IOS, you must connect the router to a terminal or to a PC with terminal emulation software. Terminal
emulation software should be configured with the following settings:
• 9600 baud
• 8 data bits
• No parity bits
• 1 stop bit
The Cisco 1700 Router Software Configuration Guide describes how to configure the router by using Cisco IOS software.
Follow these steps to connect the router to a terminal or PC:
Step 1 Connect the RJ-45 end of the console cable to the CONSOLE port on the back panel of the router, as shown in Figure 2.
Figure 2 Connecting the Console Cable to the Router
Step 2 Connect the DB-9 end of the console cable to the console port (also called the serial port) on your PC. If this adapter
does not fit your PC console port, you must provide an adapter that fits.
91645
Blue console cable
To PC or terminal
CONSOLE
AUX
FDX
WIC0OK
LINK 100
WIC 1OK
MODO
K
ACT LNK
ACT LNK
ACT LNK 4x
3x
2x
1x
WIC
4ESW
ACT LNK
SEE
MANU
AL BEFO RE INSTAL LATIO N
SP
CH
OH WIC-1AM Modem
PHONE
LINE 0
10/100 ETHERNET
Console port
Cisco 1
711
+5, +12,
-12 VDC