Chicago Electric 99702 - Manual (Page 12)

SKU 99702 For technical questions, please call 1-800-444-3353. Page 12
Allow the unit to draw paint until all air 10.
and impurities are cleansed from the
system and the paint runs pure.
Turn the power Switch to its “OFF”
11.
position and secure the return tube in
its normal operating position.
purge and prime the hose:
Do not attach the Spray Tip to the 12.
Gun when priming the Hose.
Unlock the Gun and turn the “PRIME/
13.
SPRAY” knob to the “PRIME” posi-
tion.
Oil Fill
pail
Bracket
prime/
sprAy Knob
priming
Button
return
hose
14. Aim the Gun at the side of the waste
container and pull the Trigger. If us-
ing oil-based paint, ground the Gun
by holding it against the side of the
metal container.
Hold the Trigger down and turn the
15.
power switch of the Sprayer to the
“ON” position.
Turn the “PRIME/SPRAY” knob to the
16.
“SPRAY” position and hold the Trig-
ger down until all air and impurities
are cleansed from the Hose and the
paint runs pure.
Release the Trigger. Turn the 17.
“PRIME/SPRAY” knob to the “PRIME”
position. Squeeze the Trigger once to
make sure that pressure is released.
Attach the spray tip:
Turn the Sprayer off. 18.
pull out and turn
the key to lock the
trigger
close the gauge
at the end of the
tip to lock the gun
19. Lock the Gun and thread the Spray
Tip on it.
painting:
Fill a paint container (not included) 20.
with paint. Follow paint manufac-
turer’s directions for the type of paint
being used. Place the suction nozzle
into the paint container.
Turn the power switch of the Sprayer
21.
to the “ON” position, turn the “PRIME/
SPRAY” knob to the “SPRAY” posi-
tion, and turn the pressure switch to
maximum.
When the motor cycles off, unlock the
22.
Gun and spray a test area.