Jaypro Sports CSGP-1 - Manual (Page 8)

Rev – 11/14 Page 8 of 11
Suspended Cable:
1. Install the eyebolts on the support structure as shown.
2. Make up one end of each of the two cables, see Figure 5. Tighten the cable
clamps using a 7/16” nut driver.
3. Estimate the approximate length of cable by measuring the height of the eyebolt
and subtracting about 41 ft.
4. Make up the other end of each cable, leaving the clamps hand tight with excess
cable left until the final length is established.
2” TYPICAL SPACING
BETWEEN CLAMPS
Figure 5
BOTTOM VIEW SHOWN
CORRECT WAY TO
INSTALL CABLE CLAMPS,
ORIENT THE SADDLE ON
THE CONTINUOUS
CABLE LENGTH SIDE.