Jaypro Sports FBGP-700C - Manual (Page 4)

T:\Aftermarket\Football\Drawings\FBGP-700\DOCUMENTATION\FBGP-700Installs.doc
REVISION D 7/10 3
Insert crossbar into gooseneck. Set crossbar depth so the front edge of the crossbar is
inline with the inside edge (field side) of the end line. Once the crossbar is level, mark
(by using a center punch) and drill the holes through the gooseneck. Start with a 3/16”
bit, then a 3/8” bit and finally a ½” bit.
Mark and Drill Crossbar:
Once the holes are drilled, use the ½” bolts with two flat washers and thin lock nut.
Silicon is used on each side of the bolt to prevent corrosion.