Jaypro Sports FBGP-700C - Manual (Page 2)

T:\Aftermarket\Football\Drawings\FBGP-700\DOCUMENTATION\FBGP-700Installs.doc
REVISION D 7/10 1
FBGP-700 SERIES
OFFICIAL 6’ OFFSET FOOTBALL GOAL POST
-WITH LEVELING PLATE-
LIST OF MATERIALS
ITEM NO. PART NO. DESCRIPTION QTY.
1 HS5119 Bolt-HX HD ½”-13x5” 8
2 HS5066 Bolt-HX HD ½”-13x7 ¾” 4
3 HN268 ½”-13 LOCK NUT 12
4 HW2044 ½” FLAT WASHER 12
5 HS1616 Bolt-3/8”-16x2 ¾” 8
6 HN1230 3/8”-16 LOCK NUT 8
7 HW2047 3/8” FLAT WASHER 8
8 AF65 Top upright cap 4
9 FBGP601 ANCHOR ROD 8
10 HN5017 LOCK NUT 7/8”-9 8
11 HW5003 STANDARD FLAT WASHER 7/8” 16
12 HN5020 HEX NUT 7/8”-9 16
13 FBGP602 LEVELING PLATE 2
IMPORTANT
1) The location of the gooseneck with respect to the field is critical. By rule, the
front of the crossbar should be even with the field side (inside) edge of the end
line such that the crossbars measure 360 ft apart, inside to inside. The distance
from the end line to centerline of the bottom upright (gooseneck) is approximately
78” for the FBGP-700 series. See Figure 1
2) The footing depth is 5’-8”. Concrete should be a minimum 4000 psi mix. For
installation see Figure 2.
3) The crossbar should be level and at a height of 10 ft above ground level. The
uprights should be plumb in both directions, front to back and side to side.
Adjust goal components as necessary. Note that a certain amount of deflection in
the crossbar is to be expected due to the weight of the end fittings and uprights on
each end.
4) It is strongly recommended that a Protective Post Pad be placed around the
gooseneck when the goals are in use.