beautypg.com

Ss ee tt uu pp ii nn ss tt rr uu cc tt iioo nn ss – Intex Pool Ladder 2012 User Manual

Page 9

background image

91PO

SAVE THESE INSTRUCTIONS

Page 9

(91PO) 36", 42" & 48" 2-SECTIONS POOL LADDER ENGLISH 7.5” X 10.3” PANTONE 295U 10/13/2011

English

SS

EE

TT

UU

PP

II

NN

SS

TT

RR

UU

CC

TT

IIOO

NN

SS

LADDER SETUP (continued)

5. U-SHAPED TOP RAIL

INSTALLATION (refer to figure 4):

Install the U-shaped top rails (1)

onto the legs above the top brace

(2) and fasten them with the

shorter fasteners/screws (3)

– see figure 4.

6. INSTALLATON OF THE

REMAINING LADDER SIDE

(refer to figure 5):

With all the top rail and top brace

holes in alignment, slide the

remaining ladder side from the

underside into its proper position.

Make sure the “A” leg slides into

hole “A” of the top brace and the

“B” leg slides into hole “B” of the

corresponding top brace.

Fasten all parts using the

appropriate fasteners/screws (4)

and (3), as described earlier.

7. BEFORE USE OF LADDER:

With all parts now in place, verify

that all fasteners/screws are fully

tightened and apply downward

pressure to each step to be sure

they are fully anchored in place. If

your ladder came with a ladder

barrier, proceed to instructions for

ladder barrier installation,

otherwise proceed to placing

the ladder over the side wall of

your pool, with one side of the

ladder located inside the pool and

the other side outside of the

pool - see figure 6.

Estimated assembly time 20~45

minutes. (Note the assembly time

is only approximate and individual

assembly experience may vary.)

4

A

5

6

WARNING

• Locate ladder on a level, solid base and make sure the ladder is

stable and safe to climb.

• Remove and secure ladder away from the pool when the pool is

not in use to prevent unauthorized, unintentional or unsupervised

pool entry.

• Check all nuts and bolts regularly and before each use to ensure

the ladder is sturdy. See maintenance instructions.

8. MAINTENANCE:

Regularly check all nuts, bolts, step mounting fixtures and step mounting

pins to ensure all parts are secured properly and the ladder is sturdy.

Bring the ladder indoors and store in a safe and dry area, preferably

between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees

Fahrenheit (40 degrees Celsius).