Intex SF15110 Krystal Clear 2011 User Manual

Page 11

161

SAVE THESE INSTRUCTIONS

Page 11

(161) MODEL SF15110 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U

12/02/2010

English

IIOO

PRODUCT SPECIFICATIONS

SETUP INSTRUCTIONS

Power:

110-120 Volt AC

Amperage:

3 A

Maximum working pressure:

3.5 bar (50 psi)

Effective filtering area:

0.1 m

(1.1 ft

)

Maximum Flow Rate:

6056 liters/hour (1600 gallons/hour)

Recommended filtering media:

Use only No. 20 silica sand. Particle size

(Not included)

range 0.45 to 0.85 mm (0.018 to 0.033

inches). Uniformity Coefficient less than 1.75.

Recommended filtering media quantity: 25 Kg (55 Lbs)

Limited Warranty:

2 Years (see “Limited Warranty”)

NOTE: NOT SUITABLE FOR USE WITH KCP-LOW -SALT AUTOMATIC SALTWATER

SYSTEM (MODEL 6110/6220)

The sand filter removes suspended particles but does not sanitize your pool.

Pool chemistry is a specialized area and you should consult your local pool

service specialist for details.

TOOLS REQUIRED:

One (1) Phillips screwdriver

Pump location and mounting:

• The system must be installed on a solid level and vibration-free base.

• Provide a location protected from the weather, moisture, flooding and

freezing temperature.

• Provide adequate access, space and lighting for routine maintenance.

• Pump motor requires free circulation of air for cooling. Do not install

the pump in a damp or non-ventilated location.

A team of 2 or more people is recommended for setting up this product.

Motor pre-filtering assembly setup:

1. Remove the sand filter and its accessories

from the packaging carefully and inspect for

any visible damage. If parts are damaged

contact your local service center listed at

the back of this ownerʼs manual.

2. In a counter-clockwise motion unscrew the

leaf trap cover (14) from the pre-filter

housing. Take out the basket (16) and filter

housing nut (17) (see drawing 10).

3. Connect the pre-filter housing to the motor

water inlet. Note: Align the connector in the

pre-filter housing with the water inlet on the

motor (see drawing 11).