beautypg.com

Save these instructions, S ave these instructions, Saltwater system operation (continued) – Intex CS7111 Krystal Clear Saltwater System 2014 User Manual

Page 18

background image

SAVE THESE INSTRUCTIONS

Page 2

(189PO) MODEL CS7111 SALTWATER SYSTEM & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013

English

189

PO

S AVE THESE INSTRUCTIONS

English

Page 18

SALTWATER SYSTEM OPERATION (continued)

6. Boost cycle

If the test result is below 0.1ppm, press and hold “BOOST” button for 5

seconds until the indicator lights up and the LED display display “80”. This

indicates that the saltwater system has started copper ion and more chlorine

sanitizer production. You can press and hold the “BOOST” button for another

5 seconds until the indicator is off, which will cancel the Boost cycle.

Note: Once the system has started copper ion and more chlorine sanitizer

production, the boost button can’t be re-set until the power switch is off.

The boost operating hours is 8 times the amount of time programmed into the system, i.e. if your

saltwater system operating time is 2 hours, the boost procedure will run 8 x 2 = 16 hours. After

boost procedure has been completed, the system will automatically switch to the normal

working mode.

After a heavy rain or if the pool is dirty, press the “BOOST” button to shock the pool again.

7. Test pool water regularly:

Once the copper level appears to be balanced, test the pool water every week to maintain the

proper sanitizer level. It’s very important that the free chlorine is between 0.5-3 ppm and

copper ion concentration is between 0.1~0.2 ppm. When the copper level is below 0.1 ppm,

repeat step 6.

NOTE: A High copper ion concentration may cause blonde hair to exhibit a green hair. To

prevent this, wear a swimming cap during swimming, and wash hair with special shampoo

after using the pool. See “Troubleshooting Guide”.

8. Stand-by/power saving mode:

When the cycle ends, the green “SLEEP” indicator on the control panel lights

up and the LED display flashes “93”. The system is now in Stand-By mode.

After a while, it shuts down and sets itself in a Power Saving mode. The

system will automatically turn itself back on in 24 hours, starting its daily cycle

of chlorine production.

The “SLEEP” indicator stays on, while the system is in the Power Saving

mode. The LED display however, goes blank after 5 minutes. Press any

button ( or ) to view the last LED code.

9. Running the pump alone without the Saltwater System:

To run the pump alone without the Saltwater System function, press and hold

both and buttons until you hear a “beep”, the LED display will show

“FP”. The pump is now operating alone. NOTE: The pump cannot be

operated alone under an automatic timer mode. To stop the pump, manually

turn the switch OFF.

IMPORTANT: To keep the initial automatic operating cycle setting of the

Saltwater System, turn the switch ON, the LED display will show “FP”, and

then press until you hear a “beep”. The LED display will now show the

initial input hours and the Saltwater System cycle will repeat again.