Intex 18 FT X 52 IN ULTRA FRAME POOL 2014 - Manual (Page 7)

118
PO
SAVE THESE INSTRUCTIONS
(118PO) ULTRA FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 06/20/2013
English
Page 7
POOL SETUP (continued)
IMPORTANT
Before allowing anyone to use the pool, hold a family meeting. Establish a set of rules that
include, at a minimum, the important safety rules and general aquatic safety information in this
manual. Review these rules on a regular basis and with all users of the pool including guests.
The installer of the vinyl liner shall affix on the original or replacement liner, or on the pool
structure, all safety signs in accordance with the manufacturer’s instructions. The safety signs
shall be placed above the water line.
• Next slide the vertical legs into the belt loop located in the middle of
the pool liner. The bottom of the leg should be inside the white
restraining rope (6) (optional) located near the liner’s bottom edge.
Carefully slide the leg into the belt loop and place the leg’s bottom
inside the rope and then insert the top of the leg into the bottom of
the joint. Snap the leg into joint’s holes by aligning the hole and the
spring-loaded pin. Attach the leg’s end cap (3) to the bottom of the
leg (see drawing 3).
• Grab the frame pool’s top beams in 2 – 3 locations and "shake" the
pool to be sure all the joints, legs and beams "fit into each other".
• Pull gently, in an outward direction, the bottom of the leg making sure the leg is inside the restraining
rope.
• If pool was purchased with a filter pump, read the Krystal Clear™ Filter Pump Manual first and
then proceed to next installation step.
3. Filling of the pool
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain
cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch (2.5 cm) of water. Check
to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting up
the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging and
a potential collapse of the pool. If the pool is not completely level, you must drain the pool, level
the area or move the pool to a different area that is level, and re-fill the pool, following the above
directions.
• Smooth out the bottom liner wrinkles (from inside the pool) by pushing out where the pool floor and pool
sides meet. Or (from outside pool) reach under the side of the pool, grasp the pool floor and pull in an
outward direction. If the ground cloth is causing the wrinkles, have 2 people pull from opposite sides to
remove all wrinkles. Use the properly assembled pool ladder when entering or exiting the pool during this
process.
IMPORTANT: For certain pool models with restraining rope at the bottom – Never pull from the
restraining rope to smooth out the floor wrinkles as this may cause pool liner damage or leakage.
• Fill the pool with water up to just below the sleeve line (see
drawing 4).
4. Posting aquatic safety signs
Select a highly visible area near the pool to post the Danger No
Diving or Jumping sign included later in this manual.
3
3
WATER LEVEL
4