Intex TWIN DOWNY BED 2013 - Manual

™
Prestige Airbed
15PO
©2012 Intex Marketing Ltd. - Intex Development Co. Ltd. - Intex Trading Ltd. - Intex Recreation Corp.
All rights reserved/Tous droits réservés/Todos los derechos reservados/Alle Rechte vorbehalten.
Printed in China/Imprimé en Chine/Impreso en China/Gedruckt in China.
®™ Trademarks used in some countries of the world under license from/®™ Marques utilisées dans certains pays sous licence de/Marcas
registradas utilizadas en algunos países del mundo bajo licencia de/Warenzeichen verwendet in einigen Ländern der Welt in Lizenz von/ Intex
Marketing Ltd. to/à/a/an Intex Trading Ltd., Intex Development Co. Ltd., G.P.O Box 28829, Hong Kong & Intex Recreation Corp., P.O.
Box 1440, Long Beach, CA 90801 • Distributed in the European Union by/Distribué dans l’Union Européenne par/Distribuido en la unión
Europea por/Vertrieb in der Europäischen Union durch/ Intex Trading B.V., Venneveld 9, 4705 RR Roosendaal – The Netherlands
Consumer Service 1-800-234-6839
(15PO) PRESTIGE AIRBED WITH BUILT-IN FOOT PUMP SIZE: 7.5” X 10.3” 05/21/2012
Comfort-Rest
™
READ AND FOLLOW ALL INSTRUCTIONS
BEFORE INFLATING OR USE
BEFORE INFLATING WITH BUILT-IN PUMP
• Spread the airbed out on a flat surface. Make sure this surface
is free of stones or others sharp objects which might puncture
the airbed.
• The built-in air pump inflation valve must face up.
• Make sure that the insert plug is properly positioned and the
2 in 1 exhaust valve cap is securely tightened.
TO INFLATE USING THE BUILT-IN PUMP
• Remove the air pump inflation valve cap and insert plug .
Save the cap and plug to reattach after inflation.
• Locate and spread the built-in foot pump out to ensure the foot
pump surface is flat and straight.
• Placing your foot directly over the inflation valve opening,
push firmly down . This will push air from the air pump
chamber into the bed.
• Release your foot so the air pump chamber will re-fill
with air for the next cycle.
• Repeat until desired firmness is achieved.
• Replace the air pump inflation valve insert plug and cap .
TO INFLATE USING AN EXTERNAL AIR PUMP
• Make sure the air pump inflation valve insert plug is properly
positioned and the 2 in 1 exhaust valve cap is securely
tightened.
• Pull 2 in 1 valve cap to open.
• Insert the nozzle from an air pump into the 2 in 1 inflation
valve.
• Inflate the product to approximately 80% of desired firmness.
CAUTION: To prevent bursting, do not over inflate or use
high pressure air compressor.
• Close 2 in 1 valve cap securely after inflation.
TO DEFLATE
• Pull out 2 in 1 valve cap.
• Pull inflation valve base to release air.
CAUTION: When opening, point the exhaust valve away from
any person.
• Replace inflation valve base and cap securely.
–––– SAVE THESE INSTRUCTIONS ––––
WITH BUILT-IN PUMP
1
2
4
1
3
2
2
2
2
2
1
1
015-*PO-R0-1305
IMPORTANT
Air inside of bed may expand and contract with varying temperature
leading to reduce pressure inside of the bed. If this occurs, simply
add more air using the pump to achieve desired firmness. If puncture
occurs, please refer to instruction. Repair kit/patch is enclosed.
3
4
ENGLISH
1
2
2
DEFLATE
INFLATE