Harbor Freight Tools Model 99637 - Manual (Page 7)

SKU 99637 For technical questions, please call 1-800-444-3353. Page 7
PRODUCT SPECIFICATIONS
Air Pressure Range 70-90 PSI
Air Hose Requirement 3/8” I.D.
Air Inlet
1/4” -18 NPT
Air Consumption 6.0 CFM
Fastener Type Staples with Plastic Caps
Staple Length 3/8” to 1-1/4”
Staple Crown Size 3/8” Crown
Staple Gauge 18 Gauge
Plastic Cap Diameter 1” O.D.
Plastic Cap Capacity 100 Plastic Caps
Magazine Capacity Strip of 100 Staples
Firing Method Intermittent Single Fire
Safety Trigger
Single Sequential Safety Trip
Mechanism
Adjustable Drive
Depth
Rotational Knob at Left Side of
Stapler
PRODUCT FEATURES
FIGURE A
DRIVE DEPTH
ADJUSTER
(47)
MAGAZINE
LATCH
(63)
TRIGGER
(39)
BOTTOM PLATE
(95)
CANISTER
LATCH
(104)
PLASTIC
CAP
CANISTER
(105)
EXHAUST
CAP
(1)
MAGAZINES
A & B
(67, 73)
TOOL SET UP/ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
• This air tool may be shipped with a
protective cap covering the Air Plug
(57). Remove this cap before set
up.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
REV 08k