Chaparral K5312/K7313 - Manual (Page 137)

Troubleshooting
9-13
Voltage and Temperature Errors and Warnings
Most voltage and temperature errors occur due to the enclosure. Check the enclosure
configuration first.
❒
43 I/O request was aborted because of third-party channel reset
(displayed as “Abort 3PRST”).
44 Controller decided to abort I/O request for reasons other than bus or
target reset
45 I/O request was aborted because of target reset requested by controller
46 Target did not respond properly to abort sequence
4B I/O aborted due to operating mode change (such as LVD to SE or SE
to LVD) (displayed as “Abort MdChg”).
50 Disk channel hardware failure (displayed as "DskChn Fail") This
may be the result of bad termination or cabling.
Table 9-5. Disk Channel Error Codes (Continued)
Error Code Description