Daily safety check, 33 daily safety check, Daily safety check 34 – Crown Equipment RR 5200S Series User Manual
Page 18
2. Test drive your truck in an uncongested area.
• Try all the hydraulic functions.
• Check that the steering is easy and smooth.
• Drive the truck slowly in both directions.
• Drive through the full speed range in both forward
and reverse.
• Check braking and plugging distances in forward
and reverse. Load size and floor conditions can affect
these distances.
• Know the distance it takes to stop before you start
working. If the braking distance is too long to stop
safely, don't drive the truck.
If anything doesn't look or feel right, don't drive the truck.
Report the problem to your supervisor.
You can get checklist forms from your Crown dealer
(part no. OF-3772). Used properly, this checklist can alert
service people to needed repairs.
Daily Safety Check
33 Daily Safety Check
CHECK YOUR TRUCK BEFORE STARTING WORK
You must make sure your truck is safe to use.
1. Walk around your truck and check it over.
• Check to make sure the battery is charged, water level
is OK and vent caps are in place. Don't use an open
flame to check the battery.
• Make certain the battery retainer is properly installed
and adjusted.
• See that all wheels are in good condition.
• Clean the safety glass.
• Check that both forks are secure and not bent, cracked
or badly worn.
• Inspect lift chains for damage.
• See that the load backrest and overhead guard are in
place and fastened.
• Look under the truck for signs of hydraulic leaks.
• Turn the key to TEST (yellow dot). See that all display
lights are working.
• Test the horn.
• Make sure the power disconnect works.
Daily Safety Check 34