beautypg.com

Display panel messages, Switch panel, 17 display panel messages – Crown Equipment RR 5200S Series User Manual

Page 10: Switch panel 18

background image

----

MESSAGE DISPLAY FOR STANDARD TRUCK
If your truck slows down or won't work, check the message display for instructions.

Display Panel Messages

AUDIO ALARM
Anytime you hear a "beep", something is wrong. Check the message display.

17 Display Panel Messages

Optional Expanded
Message display

Standard
Message Display

Load is too heavy for the lift zone you
are operating in.

Check that the alarm, message display
and all lights are working.

TEST

Both feet must be on the correct pedals/pad.

FOOT

Return the multi-task control handle to

neutral.

HAND

Make sure battery retainer is in place
and secure.

DOOR

Remove your foot from the entry bar.

ENT

What To Do

RCUT

Forks are at cutout height. Use the cutout
override switch to continue raising.

ADDITIONAL MESSAGES FOR CAPACITY DATA MONITOR OPTION
If your truck has this option, the following messages can also be displayed.

Make sure the forks are not tilted all the
way up or down. If the problem continues,
notify your service department or supervisor.

CTR

During start-up, briefly move left foot
to the Center Brake Pedal.

Enter your user code (PIN number).

LAMP TEST

LEFT OR RIGHT PEDAL

CENTER HANDLE

ENTRY BAR

BATTERY DOOR

USER CODE: / - - -

RAISE CUTOUT

CENTER PEDAL

CHECK LOAD

MONITOR DISABLED

Switch Panel 18

Switch Panel

RAISE CUTOUT OVERRIDE SWITCH (optional)
Your truck may be equipped with automatic cutout of raise
at selected lift heights.

To raise past the cutout height, push the optional Raise
Cutout Override switch while, at the same time, lifting the
multi-task control handle (see page 29).
Caution: Make certain the load and load backrest will
clear all overhead obstructions.

DOME LIGHT SWITCH

FAN SWITCH (optional)

WORK LIGHT SWITCH (optional)