Fork functions, Know the hazards, 29 fork functions – Crown Equipment RR 5200S Series User Manual
Page 16: Fork functions 30
Fork Functions
29 Fork Functions
RAISE/LOWER
Lift the multi-task handle up to raise the forks. Push down
on the handle to lower the forks.
The farther you move the multi-task handle from neutral,
the faster the forks will move.
RAISE CUTOUT OPTION
Your truck may be equipped with an automatic cutout to
prevent you from raising the forks into restricted areas.
If raise stops, check the message display. or
will show on the display if you
are at a raise cutout height. See page 18 for using the
optional Raise Cutout Override Switch.
RCUT
FORK FUNCTIONS
Standard fork functions include
Raising and Lowering the forks, Tilt (up and down),
and Reach (extend and retract).
Some optional fork functions your truck may be equipped
with are Sideshift (right or left), Rack Height Select which
allows the truck to be programmed so the forks will stop
at selected heights, and Tilt Position Assist to tilt the forks
to a programmed position.
RAISE CUTOUT
Fork Functions 30
2
3
RACK HEIGHT SELECT OPTION
This option allows a truck to be programed so the forks
will stop at a selected height.
1. Press the UP ARROW button on the right side of the
display panel to activate the rack select option. The
message display will show if at
least one lift height has been programed into the truck,
and your truck is equipped with this option.
2. Press the switch on the back of the multi-task handle
to scroll through the lift heights that have been programed
into the truck. The message display will show the height
in either millimeters or inches, along with the label
number for the height.
3. Make certain the path of the forks is clear. Lift and
hold the multi-task handle. The forks will stop and
there will be a one second beep when they reach the
programed height. Check to make certain the forks are
at the correct position before entering the rack or pallet.
Know the Hazards
CHECK THE PATH OF THE FORKS
Be just as careful raising the forks with the rack height
select option as when using manual raise. Make certain
the path of the forks is clear and free of obstacles.
Check that the forks are at the proper position to enter
the pallet, or that the pallet will clear the rack beam..
1
RACK SELECT