Campbell Hausfeld IN469403AV - Manual (Page 10)

10
Pressure Washer
www.chpower.com
Maintenance
WINTerIzING INSTruCTIONS
1 . Follow and complete the Long Term Storage Instructions
above .
2 . Disconnect the spark plug wire .
3 . Disconnect the high pressure hose from the pump .
4 . Insert a 12 inch to 14 inch piece of garden hose into the
pump inlet .
5 . Place a funnel in the other end of the garden hose .
read the manufacturer’s instructions
for safe handling and disposal of rV
antifreeze.
6 . Pour approximately 6 oz . of RV antifreeze into the funnel .
7 . Pull the starter rope several times until the RV antifreeze
comes out of the pump outlet .
8 . Disconnect the high pressure hose from the gun and drain
the hose . Hold the gun and lance in a vertical position and
squeeze the trigger to drain the water out .
TIPS FOr exTeNDING THe LIFe OF YOur PreSSure
WASHer
1 . Never operate the unit without water .
2 . Your pressure washer is not meant to pump hot water .
Never connect your pressure washer to a hot water supply
as it will significantly reduce the life of the pump .
3 . Running the unit for more than one minute without
spraying water causes heat to build up in the pump .
Running the unit without spraying water can damage
pump components .
Observe regular maintenance intervals to ensure maximum
performance and life from the pressure washer . Refer to the
schedule for recommended maintenance . If you operate the
pressure washer in dusty conditions, perform maintenance
checks more often .
eNGINe OIL CHANGING INSTruCTIONS
Drain the engine oil when th engine is warm . Warm oil drains
quickly and completely .
1 . Turn the fuel valve to the OFF position to reduce the
possibility of fuel leakage .
2 . Place a suitable container next to the engine to catch the
used oil .
3 . Remove the oil filler cap/dipstick and drain the oil into the
container by tipping the engine toward the oil filler neck .
Please dispose of used motor oil in a manner that is
compatible with the envirionment . We suggest you take
used oil in a sealed container to your local recycling center or
service station for reclamation . Do not throw into the trash,
oust it on the ground, or pour it down a drain .
4 . With the engine in a level postion, fill to the upper limit
mark on the dipstick with the recommended oil .
running the engine with a low oil level
can cause engine damage.
5 . Reinstall the oil filler cap/dipstick securely .
PuMP OIL CHANGING INSTruCTIONS
Changing or refilling the oil in the pump requires removal of
the pump from the engine and should not be required unless
oil has leaked out due to worn or damaged oil seals in the
pump . If oil has leaked out of the pump, bring the pressure
washer to a certified Campbell Hausfeld service center for
repair .
Oil filler neck
Oil filler cap/
dipstick
Upper limit
Figure 14 – Oil Drain Location