Char-Broil INFRARED 10401582 - Manual (Page 4)

4
ASSEMBLY GUIDE
Part Qty
A1 – Cart RH Side Fascia 1
A2
– Cart Base 1 A3
– Cart Foot 2 A4
–
Fasteners
#10x3/4"
(qty 2)
GRILL CART Assembly
Wheels 2
(qty 14)
screw Axle Rod
(qty 2)
Wheel Retaining
Clip
Step 2: Carefully place the cart assembly on its
back. Install the Cart Feet (A4) by
threading them into the bushings as shown.
Step 3: Assemble the Wheels (A5) to the Cart Base
(A3) by first sliding an axle rod through the wheel,
then sliding the axle rod through the axle rod holes
in the cart base. Secure with a wheel retaining clip.
Repeat for the other side.
Wheel Retaining Clip - install after
placing wheel and axle rod through
axle hole.
Axle Rod
Axle Hole
A5
A3
– Cart LH Side Fascia 1
A5
A1
A2
A3
Step 1: Assemble the LH and RH Side Fascia (A1 & A2)
to the Cart Base (A3) by aligning screw holes in the
fascias with corresponding holes in the cart base.
Secure with 7 each, #10x3/4 screws (7 per side) using a
phillips screwdriver. Repeat for other side. NOTE: The
lift handles are shown in the up position. You can
complete steps 1 and 2 with the handles lowered if
desired.
A4
A3
Wheel retaining clip -
Install after wheel and axle rod
through the hole as shown in
this direction only.
Clip shown properly installed.
Securely tighten the cart feet.