Philips g380 - Manual (Page 12)

Clipping with hair comb attachment
D
Put the hair clipper comb on the full width
trimmer attachment and push until you hear
it ‘click’ into place (fig. 19).
B Press the Hair Length Selector and slide it to
the desired setting. See Table 2.
B The setting selected will appear in the
window to the left of the Hair Length
Selector (fig. 20).
When you are clipping for the first time, start
at the maximum clipping length setting (#9)
to familiarize yourself with the appliance and
prevent accidentally trimming hairs too short. As
you become familiar with the settings, adjust the
Hair Length Selector to desired trimming length.
Selector will ‘click’ into position at each setting.
Table 2. Hair Clipper
Setting Remaining hair length
(in) /(mm)
1 . 16 iny4mm
2 .24 iny6mm
3 .31 inySmm
4 .39 inyiOmm
5 .47 inyi2mm
6 .55 in7l4mm
7 ,63 in7l6mm
8 .71 inyiSmm
9 .79 iny20mm
□ Make sure that the flat part of the comb is
always in full contact with the scalp to obtain
an even result (fig. 21-22).
B Move the appliance slowly over the crown
from different directions to achieve an even
result (fig. 23).
Q Always move the appliance against the
direction of hair growth.
B Make overlapping passes over the head to
ensure that all hair that should be cut has
been cut.
□ Turn the Groomer off and remove the hair
comb often to blow and/or shake out hair
that has accumulated.
I REMEMBER;You must reset the hair length
selector back to your desired setting every
time you replace the hair clipping comb on the
appliance.