Philips g380 - Manual (Page 10)

Trimming Nose Hair
I Make sure nasal passages are dean.
n Place nose, ear and eyebrow attachment on
Groomer.
a Switch the Groomer on and insert the tip of
the attachment into one nostril (fig. 14).
CAUTIO_N;.Po Not insert more
tbaoJ/l6jnJ5nimJntQ_your_no$tri(>
il Slowly move the tip in and out while
turning it around at the same time in order
to remove unwanted hair. For best results,
make sure the side of the tip is firm against
skin.This will reduce the tickling effect that
can occur during trimming of nose hair.
□ Turn off Groomer. Rinse attachment clean
after each use.
Trimming Ear Hair
I Clean outer area of car and ear canal. Make
sure it is free of wax.
t
Nose, ear and eyebrow attachment should be
on the Groomer.
D
Switch the Groomer on and move the tip
softly around the edge of ear to remove hairs
extending beyond the outer ear (fig. 15).
D Carefully insert the tip into outer ear canal.
CAUTION; Do not insert the tip further
than 3/.!.^ into the w this
could cause damage to the eardrum
(f!g.i 6 >.
□ Turn off Groomer. Rinse attachment clean
after each use.
Trimming Eyebrow
I Nose, ear and eyebrow attachment should be
on Groomer.
D
Switch the Groomer on and use the tip to
cut individual eyebrow hairs.
The Groomer can be used for clipping single long
hairs.
□ Put the Groomer at the root of the hair and
move it along the edge of the eyebrow from
the base of the nose towards the outer tip of
the eyebrow in the direction of hair growth
(fig. 17).
IMPORTANT Do not uv.'* the Gioonvri to define
or trim the crititQ oyobiov«' Do not nv to trim
/our cveUsbes. Be c-veful noi to got too clO’^c to
vour eyelashes and eves!
□ Turn off Groomer. Rinse attachment clean
after each use.