Philips AZ 6804 - Manual (Page 10)

PLAYING A DISC
• Ensure that the HOLD switch is in position OFF.
• Connect headphones to the socket
• Press OPEN to open the disc cover.
• Insert the disc, printed side facing up (fig. 2) and
close the cover.
• Adjust the sound with the VOLUME control and the
DBB bass switch.
• Playback will start by pressing PLAY >. As soon as
playback starts, the display shows the track number 1
and the elapsed playing time of the first title. When the
second title is reached the track number 2 appears,
etc.
• For brief interruptions, press PAUSE ii. The word
PAUSE appears. To continue playback, press PAUSE
II again.
• To stop playback, press STOP. Now the display
shows the total playing time and the number of tracks
present on the disc.
• Open the disc cover only if the CD-player is in
position STOP.
• In the STOP position, the CD-player automatically
shuts down shortly after the last command, normally
after 30 seconds and if a program is stored after
3 minutes. 10 seconds before shut-down the display
starts flashing.
Remarks
• The CD player also goes to position STOP;
- when the end of the disc is reached:
- by opening the disc cover:
- if the battery gets exhausted or if the power supply
is interrupted in another way.
• If the battery gets exhausted, the CD-player will not
function normally, e.g. it does not start. ’E' for Error
appears, etc. In this case, recharge the battery and/or
connect the charger to the DC 5-6 V socket.
• If PLAY > is pressed and the CD-player shuts down
after some seconds, the CD-player cannot read the
disc. Possible causes are:
- you inserted the disc the wrong way: the label should
face up (fig. 2);
- the surface of the disc is badly scratched or dirty,
see 'Maintenance':
- the lens 0 (fig.3) is steamed up because of a
sudden transition from a cold into a warm environ­
ment: do not clean the lens, but let the set ac­
climatize for a while:
- the battery is exhausted. Recharge the battery
and/or connect the charger to the DC 5-6 V socket.
10