Philips NORELCO CC5060 - Manual (Page 7)

I This cut allows you to achieve a smooth
transition from longer hair on top of the
head to shorter hair on the back and sides
of the head.
□ Slide the large comb into the guiding grooves
on both sides of Clipper and push until you
hear it 'click' into place (fig. 6).
B Press the Hair Lengdi Selector (1) and slide
it to the maximum setting (2) of 1 3/4 ini
42 mm (fig. 7).
B
Clip the desired areas of the head.
n Then choose a shorter setting and cut all
parts of the head except the top where you
want the hair to be longer.
B Repeat until all hairs have the desired length.
Cutting over Styling Comb or Fingers
I This technique can be used to obtain hair
lengths over 1 3/4 ini42 mm.
n Remove the hair comb attachment by
pressing the Hair Length Selector (1) and
sliding the comb off the Clipper (2) (fig. 8).
Never
Dull
off a comb bv grasping the flexible too
portion Always pull off by ihe bouom p.irt of
attachment.
B
Comb a small section of hair upwards.
B
Lift the hair with the styling comb and hold it
between your fingers.
The amount of hair you wish to cut should extend
beyond your fingers.
□ Cut the hair extending from the fingers
or comb.
B
Continue this procedure, working from the
front to the back of the head.
□ Comb hair often to remove trimmed hair
and to check for uneven areas.
Contouring without a comb attachment
Remove the hair comb if you arc:
I Defining hair lines
i
Trimming nape of neck
I Removing single, unwanted hairs
The Fade
C'i’yfu! '.vH?n you ,|iQ clipping Without ..■ v.)
attachment as when the Qipoer is tumeo on it
will remove every hair it touches.
□ 8e certain Clipper is in the OFF position.
B
Remove the hair comb attachment by
pressing the Hair Length Seleaor (1) and
sliding the comb off the Clipper (2) (fig. 8).
Never Du') off .1 comb bv grjsping flexible I
qd
.
portion, AKvavs pull oH bv the bottom part of
aufl&hineni
B
To contour the hairline around the ears,
comb the hair ends over the ears.
□ Tilt the Clipper in such a way that only
one edge of the cutter blades touches the
hair ends when you shape the contours
around the ears.
Only cut the hair ends. The hairline should be
close to the ear
B
To contour the nape of the neck or
sideburns, turn the Clipper and hold it with
the cutter blades pointing downwards.
□ Move the Clipper slowly and smoothly
following the natural hairline.