Philips NORELCO CC5060 - Manual (Page 5)

To Charge/Rccharge
I Fully charge Clipper before using for the first
time, after non-use for a long period of time or
when the green charging light turns orange.
¥
Charging or recharging at temperatures below
40’F or higher than 95'F adversely affects
lifespan of the battery.
I Do not charge Clipper in a pouch.
I Always unplug Clipper from the elearical outlet
immediately after use, except when Clipper is
(re)charging.
a
Be certain Clipper is OFF.
Q Open the adaptor cover and insert the
adaptor directly into the Clipper (fig. 1) and
plug the appliance plug into any 120V AC
outlet Use only the cord provided.
I An adaptor plug may be necessary for
cord usage in some foreign countries. Use
an attachment plug adaptor of the proper
configuration for power outlet
a
After a few moments, the green Charging
Light on the appliance will blink to indicate
the Clipper is charging (fig. 2).
I It will take approximately 8 hours to fully
charge the Clipper for a cordless clipping
time of up to 45 minutes.
a After the Clipper is fully charged, the green
Charging Light will light up continuously.
B Disconnect the cord and unplug from
electrical outlet
Corded Hair Clipping
D
Open the adaptor cover and insert the
adaptor provided to Clipper and plug
Clipper into electrical outlet (fig. 1).
B Turn Clipper ON by pressing the ON/OFF
Button once (fig. 3) and begin clipping.
B
Turn Clipper OFF and unplug.
Cordless Hair Clipping
D
Charge according to directions. Unplug
Clipper from outlet and remove cord.
B
Turn Clipper ON by pressing the ON/OFF
Button once (hg. 3) and begin clipping.
B
If the charge runs low while clipping, the
green Charging Ught will turn orange.
The Clipper still contains enough power for
approximately 15 minutes of cordless clipping.
□ If the motor starts to run slowly, simply
connect cord provided to Clipper and oudet
to continue clipping.