Philips NORELCO CC5060 - Manual (Page 6)

Hair Clipping
I Use diis Clipper for its intended household
use as described in this manual.
I Make sure that the appliance is fully charged
before you start clipping hair.
I Before you start clipping, make sure that the
head of the person whose hair you are cutting
is at the same level as your chest so that all
parts of his/her head are clearly visible and
within easy reach.
I Only use the appliance on clean, dry hair.
k Do not use on wet hair.
I Before you begin.comb the hair in the direction
of grov^ (fig. 4).
I To achieve optimal clipping results, always move
the appliance slowly through the hair against
the direction of hair grovtoh.
TIP: For viiuol hair dipping instructions, please
refer
to
the DVD included with your Hair
Oipper Of go to www.philtps.com/noreko.
Clipping with small or large comb
n Be certain Clipper is OFF.
B Select the comb attachment-The remaining
hair length after clipping is indicated on the
sides of each comb (fig. S).
Small comb: 1/8 - 7/8 in. (3-21 mm)
- Large comb: 1 - 1 3/4 in. (24-42mm)
B
Slide the selected comb into the guiding
grooves on both sides of Clipper and push
until you hear it ‘click’ into place (fig. 6).
Make sure ^ comb attachment locks properly
into position.
□ Press the Hair Length Selector (1) and slide
it to Uie desired setting (2) (fig. 7).
B
The setting indications on the sides of the
comb show the selected setting.
When you are clipping for the first time, start at
the maxinxim clipping length setting (7/8 in/21 mm
or I 3/4 iny42mm) of the small or large comb to
familiarize yourself wiUi the appliance and prevent
accidentaify tnrnmmg hairs too short. As you
become familiar with the settings, adjust the Hair
Length Selector to desired thnnming length.
□ Make sure that the flat part of the comb is
always in full contact with the scalp to obtain
an even result.
B
Since all hairs do not grow in the same
direction, move the appliance slowly over the
crown from different directions (i.e. upwards,
downwards and across) to achieve an even
result.
Q Always move the appliance against the
direction of hair growth.
a
Make overlapping passes over the head to
ensure that all hair that should be cut has
been cuL
EE
For best results with curly, sparse or long
hair, use the styling comb to guide the hair
towards the Clipper.
ED
Turn the Clipper off regularly during clipping
and remove the hair comb to blow and/or
shake out hair that has accumulated.
> REMEMBER;You must reset the hair length
selector back to your desired setting every
time you replace the hair clipping comb on the
appliance.
T/P:Wrrte
down the settings you hove used to create
a certain hairstyle
as
a reminder for future clipping
sessions.