Philips Perfect SRP1003/27 - Manual (Page 9)

2.2.2 Direct code entry
1
Turn on the device (TV, Cable box, Satellite
box, etc.) you wish to operate.
2
Press and hold the
(S™;) button until
the red light
indicator®
remains lit, then
release the55)
button.
3
Press and release
the desired mode
button ^v~), [
cbl
)
or^D)).
• The red light
indicator®
flashes, then remains lit.
4
Enter the 4 digit code from the code tables
(on separate sheet).
5
With the device turned on, press several
buttons to test if the device responds.
• Ifthe device responds properly, you
have successfully found a valid code for
your device.
6
Repeat steps
1
to
4
for other devices you
wish to set up the remote control for.
Write your codes down here for easy
reference later.
Device Code
TV
CBL/SAT
DVD/DVR
Notes
After a valid code entry, the red light
indicator® turns off.
For an invalid code, the red light
indicator® flashes first, then turns off.
In this case you have to enter Setup
mode again and enter a new code.
Ifsome buttons do not operate your
equipment, try one ofthe other codes
for your brand.
EN
P1003_27_Manual_80_210.indd 9 25-11-09 13:2