Uniden TRU9460 - Manual (Page 53)

52
Resetting.the.Handset.without.the.Base
If.your.original.base.is.not.available.for.some.reason.(for.example,.it.is.lost.or.somehow.incapacitated),.you.can.still.
reset.the.handset.and.use.it.with.another.base..
Press.and.hold. [ ].and.[#].for.more.than.5.seconds..
Move.the.cursor.to.select.the.BASE.UNAVAILABLE.and.then.press.the. OK.soft.
key..BASE.UNAVAILABLE.appears.
Move.the.cursor.to.select.YES,.and.then.press.the.
OK.soft.key..ARE.YOU.SURE?.
appears..
Move.the.cursor.to.select.YES,.and.then.press.the.
OK.soft.key...
You will hear a confirmation tone. The handset will delete its own base information without trying to contact
the.base..When.the.base.information.is.deleted,.the.handset.displays.MODELS.VARY!.PLACE.HANDSET.
ON.THE.BASE.FOR.REGISTRATION.OR.REFER.TO.OWNER’S.MANUAL..Register.the.handset.to.the.new.
base.(see.page.23).
Changing.the.Digital.Security.Code
The digital security code is an identification code used to connect the handset and the base. Your unit ships from the
manufacturer.with.a.preset.security.code..Resetting.this.code.is.not.normally.necessary..In.the.rare.situation.that.you.
suspect.another.cordless.telephone.is.using.the.same.security.code.or.if.you.are.instructed.to.change.this.code.by.a.
manufacturer’s.Call.Center.Representative,.you.can.change.the.code.by:
Perform.“Resetting.the.Handset”.for.all.of.your.handsets..
Re-register.each.handset.by.following.the.steps.on.page.23.
Traveling.Out.of.Range
During.a.call,.if.you.move.your.handset.too.far.away.from.your.base,.noise.may.increase..If.you.pass.the.range.limits.
of.the.base,.you.will.hear.a.beep.and.see.OUT.OF.RANGE.on.the.display,.and.then.the.handset.returns.to.standby..
)
2)
3)
4)
.
2.
B a s e U n a v a i l a b l e
Y e s
N o
BACK D E L E T E OK
B a s e U n a v a i l a b l e
Y e s
N o
BACK D E L E T E OK