Philips CD 115 - Manual (Page 9)

ADDITIONAL INFORMATION
MAINTENANCE
The CDs
• Never write on the printed side of a CD.
• Do not attach any stickers to the CD.
• Keep the shiny surface of the CD clean.
Use a soft lint-free cloth and always wipe the
disc in a straight line from centre to edge.
• Never use cleaning agents for conventional rec­
ords.
• Detergents or abrasive cleaning agents should
not be used either.
The player
• A chamois leather slightly moistened with wa­
ter is sufficient for cleaning the player.
• Do not use cleaning agents containing alcohol,
spirits, ammonia or abrasives.
The lens of the laser (Fig. 5) should not be
cleaned.
FAULTS AND THEIR LIKELY CAUSES_____________
If a fault occurs, run through the points listed be­
low before taking your player for repair. Check
whether:
- condensation has formed on the lens of the
laser due to a dramatic change in temperature:
this will disappear automatically after some
time;
- the CD has been inserted correctly with the
printed side up and that there is a CD in the
compartment;
- the CD is dirty, badly scratched or warped;
- the player has been connected to the PHONO
socket of the amplifier.
If the fault remains, try to clear it by switching the
player off and on again:
• Remove the mains plug from the wall socket.
• Insert the mains plug in the wall socket again.
If this also fails to help, consult your dealer.
TECHNICAL DATA_________________________________
Typical Audio Performance
Frequency range:............................................ 2 - 20,000 Hz
Amplitude linearity:...................................................0.02 dB
Phase linearity:.................................. 0.5“ (20 - 20,000 Hz)
Dynamic range:.............................................................. 86 dB
Signal-to-noise ratio:.......................95 dB (A-weighted)
Channel separation:......................................................94 dB
Total harmonic distortion:......................................0.015%
D/A conversion:
quadruple oversampling (176.4 kHz) with digital
filter and two 16-bit D/A-converters
Audio output level:.........................................................2Vrms
Power supply
Mains voltage and frequency:
see the type plate on the rear of the player
Power consumption:
- 10 W in PLAY mode
- 5 W in STAND BY mode
Safety requirements;..................................................... lEC 65
Cabinet
Material/finish;
metal and polystyrene with decorative trim
Dimensions (w x h x d):................360 x 100 x 280 mm
Weight:.............................................................. 2.7 kg approx.
Subject to modification
This Compact Disc piayer compiies with ra­
dio interference requirements as laid down
in EC regulations.
s:
.2
"5i
c
UJ
Under no circumstances should you repair
the player yourself, as this will invalidate
the guarantee!