Interlogix Simon XT Rev D User Manual
Page 4
4
Simon XT Talking Touchscreen Installation Sheet
Figure 1: Mounting
Opening slot
Reset button
Antenna wire opening
Mounting
hole
Mounting
hole
Power wire opening
Power plug-in
Power wire loop
Batteries
Operation
Refer to the Simon XT Touch Screen Quick Operation Guide
for basic touch screen operation information. Refer to the panel
documentation for complete Simon XT and XTi programming
and operation information.
Setting the clock
You can set the touch screen clock by setting the clock on the
Simon XT or XTi panel.
Battery replacement
When the touch screen batteries are low, the touch screen will
display the red battery icon on the Home and Settings screens.
Note:
We recommend that you replace the batteries once a
year and after any significant power outage.
1. Remove the touch screen from the mounting plate by
inserting a small screwdriver into the slot on the bottom of
the touch screen.
2. Replace all batteries being sure to follow the polarity
instructions (see “Specifications ” below for recommended
batteries).
Avoid touching the touch screen face while you are
replacing the batteries.
3. Briefly disconnect the AC power (this will clear the battery
fault).
4. Reconnect AC power.
Note:
If AC power is lost and batteries are not present or are
depleted, the touch screen will not power up until AC power is
restored (even if new batteries are installed).
Reset button
The Reset button is located on the bottom left side of the touch
screen mounting plate (see Figure 1 above). To power cycle
the touch screen, use a toothpick to depress the recessed
Reset button.
Note:
Do not press the Reset button while in programming
mode.
Clear operation
If the Simon XT or XTi panel is connected to an online service,
some information (such as a dealer logo) can be stored in the
touch screen memory. To erase touch screen memory and
restore to factory default, simply relearn the touch screen into
the panel again. The learn in process begins by clearing the
touch screen memory. To keep memory clear, learn the touch
screen into a Simon XT or XTi panel that has no online service
supported.
Troubleshooting
•
If your touch screen fails to enroll, go to the Simon XT
panel, delete that touch screen from the panel, and then
repeat the enroll procedure.
•
If the touch screen chime does not announce the zone
name completely, it is likely due to the zone information
not being sent to the touch screen during installation. To
correct the problem, delete the touch screen and relearn
the touch screen again.
•
Red text on the Door Lock page indicates an open door or
a door that is not monitored.
Specifications
Compatibility
Simon XT (version 1.3 and later), Simon XTi
Power
Input 100-240 VAC, 250 mA
Output 6 VDC, 500 mA
Batteries
Four 1.5 V, Alkaline, AAA
Dimensions (W × H ×
D)
5.5 Ч 3.6 Ч 1.1 in. (140 Ч 92 Ч 28 mm)
Color White