Operational information, Maintaining the detector, Specifications – Interlogix AP950PI User Manual
Page 4: Regulatory information, Product ordering, Contact information
Figure 10: Pet alley
Specifications
3.5 ft.
(1.1m)
Input voltage
8.2 to 15VDC
Input voltage (UL)
9.7 to 13.6 VDC
Peak to peak ripple
2V max at 12VDC
Current consumption
17mA max
Mounting height
7' to 10' (2.1m to 3m)
Relay contacts
50 mA max at 28V
Relay type
Closed loop (Form A)
Alarm time (LED and
relay)
2.9 to 3.5 seconds
Operating temperature 0° to 122° F (-18° to 50° C)
Relative humidity
93% non-condensing
RFI immunity
20V/meter from 28 to 1000MHz
Weight
0.26 lbs (120 g)
Dimensions:
Width
Depth
Height
2.9" (7.4 cm)
2.1" (5.2 cm)
4.7" (12.0 cm)
Number of curtains
9
View angle
89°
Detection range
50' (15.2m) with standard mirror and
sensitivity set to Increased 35' (10.7m) with
pet immune mirror and sensitivity set to
Standard
Operational information
When the unit is powered up, the LED turns on and the relay
contacts open for about 12 seconds, then the LED goes off
and the relay contacts close. Thereafter, the LED will turn on
and the relay contacts will open every time an alarm occurs.
The unit should be allowed to settle for at least one minute
after power-up before walk testing. When walk testing, walk
across the curtains, not directly toward or away from the unit.
Wait 10 seconds between trips to allow the unit to stabilize.
Maintaining the detector
When installed and used properly, the AP950PI provides many
years of service with minimal maintenance. To ensure proper
operation, you should walk test the unit annually.
Clean the inside of the unit with a soft bristled brush or
compressed air. Clean the outside with a damp (water) cloth as
needed to keep it free of dust and dirt. Always test the unit
after cleaning.
Regulatory information
Listings C-UL
US
Product ordering
Figure 11: Dimensions
Model # Description
AP950PI PIR, closed loop, Form A, 35 foot (10.7m) pet immune
mirror installed, 50 foot (15.2m) standard mirror included.
4.7"
12.0cm
2.9"
7.4cm
2.1"
5.2cm
Contact information
For customer support, see
Copyright © 2011 UTC Fire & Security. All rights reserved.
4
AP950PI PIR Detector Installation Instructions