Interlogix DesignLine Recessed Door Contact - Manual

P/N 466-2316 • REV D • OCT12 1
DesignLine Recessed Door Contact Installation
Instructions
Introduction
This is the DesignLine Recessed Door Contact Installation
Instructions for model TX-1510-01-1. The TX-1510-01-1 is the
industry’s most flexible supervised, recessed door contact
allowing a multitude of applications while hiding the transmitter
within a door frame. The contact uses a replaceable lithium
battery and should last five years under normal usage.
The contact comes with a standard flush-mount top and a
flanged top. Unscrew the top to access the battery or change
to a different top.
Battery installation
To install the battery, do the following:
1. Unscrew the top of the contact.
2. Carefully pull the circuit board out (Figure 1 below) of the
contact. Before removing the circuit board, notice that it
fits inside a channel on the inside of the case. Do not pull
the circuit board unit by the antenna wire.
Caution: You must be free of static electricity before handling
sensor circuit boards. Touch a grounded, bare metal surface
before touching circuit boards or wear a grounding strap.
Figure 1: Battery installation
3. Slide the battery onto the circuit board unit with the plus
(+) side up.
4. Slide the circuit board unit into the contact. Make sure you
slide it back into the channel guides for proper fit with the
tamper switch facing up.
5. Screw the top back on the contact.
When replacing batteries, use only Panasonic Lithium CR23
batteries for replacement.
WARNING: The battery may explode if mistreated. Do not
recharge, disassemble, or dispose of in fire.
Mounting
It is important to select the proper placement of the recessed
transmitter and magnet. The transmitter has two separate tops
that allow a flush mount or screw mount in case you accidently
over drill the hole or require extra support to ensure the
transmitter does not move. The magnet does not have a
second flanged top so you must be careful to ensure that the
magnet is tightly in place once installed.
To mount the transmitter and magnet, do the following:
1. Install the CR2 battery if you have not already done so
(Figure 1 above).
2. Select a location on the door frame for the TX-1510-01-1
transmitter and magnet to be installed (Figure 2 on page
2). Use a marker to mark the placement and ensure that
the two holes you intend to drill are lined up directly across
from each other.
Tamper
sw itch
Antenna
Contact
Battery
Circuit
board