Interlogix TruVision IP Open Standards Outdoor Cameras Installation Manual - Manual (Page 13)

Installation Manual 13 EN
Pan
Lock screw
Rotate
Tilt
6. Reattach the dome liner and enclosure.
Mounting a TVD-CB5 to a dome camera
You can mount a TVD-CB5 cup base to the following dome camera models:
• TVD-N225E-2M-N
• TVD-N225E-2M-P
• TVD-M1245E-2M-N
• TVD-M1245E-2M-P
• TVD-M3245E-2M-N
• TVD-M3245E-2M-P
• TVD-M5225E-3M-N
• TVD-M5225E-3M-P
When assembling a TVD-CB5 to a dome, you require the following items:
• CB cup base
• Dome housing
• Rubber ring
Ensuring a good seal with the rubber ring
When mounting a dome to the TVD-CB5, a rubber ring is required to seal the gap
between them.
It is important to use the rubber ring in the correct orientation in order to ensure
an effective seal between the dome and CB5 cup base.
The rubber ring has a concave slot.
It is important that this slot is correctly
aligned with that of the dome housing
during assembly.