Interlogix TVD-7125VE-2 User Manual - Manual (Page 17)

TruVision TVD-7120VE-2 / TVD-7125VE-2 Camera User Manual 15
Delay CNT: This is the time in seconds before Day↔Night switches. A long
delay response would be used, for example, to avoid switching from Night to
Day mode when car headlights pass in front of the camera.
Day→Night: Set the threshold level on how dark it should be before switching
from Day to Night mode. Lower (Higher) value makes the camera switched
from Day to Night at lower (higher) illumination
Night→Day: Set the threshold level on how light it should be before switching
from Night to Day mode.
CAUTION: If there is a minimal difference between the Day→Night and
Night→Day values, then camera may switch between Day and Night mode
repeatedly.
B/W mode:
B/W mode can increase the sensitivity in low lighting conditions.
On the B/W submenu, you can switch it to ON or OFF to enable or disable
BURST.
EXT1/EXT2 mode:
EXT1/EXT2 mode enables synchronization of day/night and IR light.
Set the image noise reduction
In the Setup Menu, go to NR and select the desired mode. Set the noise
reduction strength of the luminance signal (Y).
Set the camera ID
In the Setup Menu, go to Camera ID and press Enter to display the menu. The
camera ID displayed on-screen can have up to 40 characters.