Interlogix NS3500-28T-4S Quick Start - Manual (Page 6)

- 6 -
3. Terminal Setup
To configure the system, connect a serial cable to a COM port on a PC or notebook computer and to
RJ-45 type of console port of the Managed Switch.
Figure 3-1
Managed Switch Console Connectivity
A terminal program is required to make the software connection to the Managed Switch.
1. Run terminal program on the OS.
2. When the following screen appears, make sure that the COM port should be configured as:
 Baud
: 115200
 Data bits
: 8
 Parity
: None
 Stop bits
: 1
 Flow control
: None
Figure 3-2
COM Port Configuration