Intellijel Cylonix Shapeshifter v1.03 - Manual (Page 27)

27
Version
This manual is for version 1.03 of the module’s firmware.
To determine the firmware version, press the QUANT., INT.SYNC., LFO (twice), CHORD MODE, and PERC. MODE
buttons, so that their (six) corresponding LEDs light up (note that you want to have both of the LFO 1 and 2 LEDs
light up). When this is accomplished, the LCD screen will alternate between displaying “shapshft/ver 1.03”, some
Japanese characters, and “CYLONIX/intllijel”. If there is no “shapshft/ver 1.03” (or other version display) then
your module has the original (ver 1.00) firmware. Note that a display of “ver 1.1” actually indicates version 1.01.
Please refer to Appendix C of this manual for instructions on updating the module’s firmware.
Version 1.03
• Added: 4 new MODA destinations, swapping Osc2 by Osc1 in the Phase, Combo, and Shape destinations,
and swapping the Carrier and Modulator in the vocoder.
• Changed: The modulation range for the Phase modulation (by MODA) and the Tilt function (internal self-
phase modulation of Osc1) has been increased 4-fold.
• Fixed: In version 1.01 and version 1.02 the Shape1 and Shape2 parameters were coarsely quantized when
Morphing between panel and preset settings in Preset Morph mode. The Shape parameters now smoothly
morph between settings.
• Fixed: The pitch of oscillator 2 increased when changing the Multi mode with QUANT turned on. The pitch
now remains constant over all multi modes.
Version 1.02
• Added: Users can now choose between just intonation or equal temperament tunings in chord mode.
• Added: Holdsync mode has been changed to do holdsync for osc1 and oneshot for osc2.
• Added: A confirmation message is now displayed when a preset is loaded.
Version 1.01
• Added: The version number of the firmware is now displayed when entering the SplashScreen display.
• Fixed: In version 1.00 there were small discontinuities in the waveforms when the Shape1 and Shape2 pa-
rameters were rapidly modulated. These have been eliminated.
Changelog