I.C.E. HTDM Food Process Unit User Manual
Page 37

37
ICECON1 to ICECON2 Upgrade
1. To operate correctly the unit must be equipped with a Belimo
NF24-SR US(or factory approved optional actuator) and ball valve
combination for gas modulation. The unit will not operate
unless equipped with the correct actuator.
2. Uncouple the 6,8 and 10 pin connector from the ICECON1
controller.
3. Remove the ICECON1 controller from the control panel.
4. If necessary rearrange components to accommodate larger size of
ICECON2 controller.
5. Remove the end connector of the 10 pin connector and expose the
individual wires (approximately 3 inches).
6. Strip ends of individual wires exposing approximately ¼ inch of
wire.
7. Attach wires according to the following diagram
Termin
al
Connect to
J1-1
24 VAC Neutral on
control panel
J1-2
Red wire from 10 pin
connector
J1-3
Purple wire from 10 pin
connector
J1-4
Grey wire from 10 pin
connector
J1-5
Yellow wire from 10 pin
connector
J1-6
Orange wire from 10 pin
connector
J1-7
White wire from 10 pin
connector
J1-8
Blue wire from 10 pin
connector
J1-9
Black wire from 10 pin
connector
J1-10
Brown wire from 10 pin
connector
8. Completely remove the 6 pin connector from the control panel.
Use the sensor leads to wire into the ICECON2 Controller for the
following connections.