HONDA 2004 Civic Coupe - Owner's Manual - Manual (Page 126)

The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob or the AM/FM
button. Adjust the volume by turning
the same knob.
Pushing the AUDIO DISPLAY
button will also turn on the system.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
XM Satellite Radio information is
available on page
.
You can use any of five methods to
find radio stations on the selected
band:
the
preset bars/icons, and
.
Use the TUNE bar or
knob to tune the radio to a desired
frequency. Press the
side of the
bar or turn the knob to the right to
tune to a higher frequency, and
press the
side or turn the knob
to the left to tune to a lower
frequency.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
or side of the
bar, then release it.
The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it, or touch the SCAN
icon on vehicles with navigation
system. You will see SCAN in the
display. The system will scan for a
station with a strong signal. When it
finds one, it will stop and play that
station for about five seconds.
If you do nothing, the system will the
scan for the next strong station and
play it for five seconds. When it plays
a station you want to listen to, press
the SCAN button or touch the SCAN
icon again.
128
For Vehicles with Navigation System
CONTINUED
Playing the Radio
Comf ort and Convenience Features
To Play the Radio To Select a Station
TUNE, SEEK, SCAN,
AUTO
SELECT
TUNE
SEEK
SCAN
123
Main Menu Table of Contents