Playing the radio – HONDA 2006 Insight - Owner's Manual User Manual

Page 82

The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Turn the system on by
pushing the PWR/VOL knob or the
FM/AM button. Adjust the volume
by turning the PWR/VOL knob.

The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the FM/AM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.

You can use any of five methods to
find radio stations on the selected
band:

the

preset buttons, and

Use the TUNE knob to

tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a

lower frequency.

The seek function

searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the

side of the

bar, then release it.

Each preset button can

store one frequency on AM and two
frequencies on FM.

Select the desired band, AM or
FM. FM1 and FM2 let you store
two frequencies with each preset
button.
Use the tune, seek, or scan
function to tune the radio to a
desired station.
Pick a preset button, and hold it
until you hear a beep.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.

The preset frequencies will be lost if
your vehicle’s battery goes dead, is
disconnected, or the radio fuse is
removed.

The SCAN function

samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan for
a station with a strong signal. When
it finds one, it will stop and play that
station for about 5 seconds.

If you do nothing, the system will
scan for the next strong station and
play it for 5 seconds. When it plays a
station you want to listen to, press
the SCAN button again.

CONTINUED

Playing the Radio

To Play the Radio

To Select a Station

TUNE, SEEK, SCAN,

AUTO SELECT

TUNE

SEEK

Preset

SCAN

Fe
a

Main Menu

Table of Contents