HONDA 2006 Insight - Owner's Manual - Manual (Page 76)

On vehicles with automatic
transmission (CVT), see page
for
Automatic Climate Control and
Manual Operations information.
You can manually select the fan
speed by pressing the fan control
button (
/ or ). The
fan speed is shown by bars in the
display.
Turning this dial clockwise increases
the temperature of the airflow.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
This button turns the rear window
defogger off and on (see page
).
Press the mode control button to
select the vents the air flows from.
Some air will flow from the
dashboard corner vents in all modes.
Air flows from the center
and corner vents in the dashboard.
The system should be left in Fresh
Air mode under almost all conditions.
Keeping the system in Recirculation
mode, can cause the windows to fog
up. If the cooling provided in ECON
mode is not adequate, press the Auto
button (see page
).
When the recirculation indicator is
on, air from the vehicle’s interior is
sent throughout the system again.
When the indicator is off, air is
brought in from the outside of the
vehicle (fresh air mode).
The outside air intakes for the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
If the A/C is on, pressing this button
allows the auto idle stop to work only
when the outside temperature is
above 41°F (5°C). For more
information, see pages
and .
78
58
78
118 111
CONTINUED
Vents, Heating, and A/C
Fan Control
Temperature Control Dial
Rear Window Def ogger Button
ECON Button
Mode Control Button
Recirculation Button
Fe
a
tu
re
s
75
Main Menu Table of Contents