HONDA 2006 Insight - Owner's Manual - Manual (Page 47)

This indicator also blinks several
times when you turn the ignition
switch from the ON (II) position to
the ACCESSORY (I) or the LOCK
(0) position.
This indicator comes on with the
high beam headlights. For more
information, see page
.
This indicator comes on for a few
seconds when you turn the ignition
switch to the ON (II) position. It will
then go off if you have inserted a
properly-coded ignition key. If it is
not a properly-coded key, the
indicator will blink, and the engine
will not start (see page
).
On Canadian models, this indicator
comes on with reduced brightness
when the daytime running lights
(DRL) are on (see page
).
This indicator comes on when you
turn the ignition switch to the ON
(II) position with the headlight
switch off and the parking brake set.
It should go off if you turn on the
headlights or release the parking
brake. If it comes on at any other
time, it means there is a problem
with the DRL. There may also be a
problem with the high beam
headlights.
This indicator comes on as a
reminder that you must refuel soon.
This indicator comes on if either
door or the hatch is not closed
tightly.
When the indicator comes on, there
is about 1.00 US gal (3.8 ) of fuel
remaining in the tank before the
reading reaches E. There is a small
reserve of fuel remaining in the tank
when the fuel gauge reading does
reach E.
56
56 60
Canadian models only
Instrument Panel Indicators
High Beam Indicator Immobilizer System
Indicator
‘‘Daytime Running
Lights’’ Indicator
Low Fuel Indicator
Door and Hatch Open
Indicator
46
Main Menu Table of Contents